MasterTile WP 665 | Waterproofing for terrace and balcony
Cementitious, one-component, rigid waterproofing compound, for indoor waterproofing, with a tile finish
Basement floor waterproofing
Floor waterproofing in the apartment
Waterproofing the garage floor
MasterTile WP 665 | One -component, cement-based rigid waterproofing for the protection of concrete, concrete floors and cement-based plasters.
-
It is used under the protection of tiles or screeds.
- Complies with EN 1504-2.
Application area
-
For outdoor and indoor work.
-
On horizontal and vertical surfaces.
- It is used for waterproofing tanks, pools, basements, foundations, open terraces and wet rooms.
Features and Benefits
- Easy to use.
-
Apply by brush, trowel or spray.
-
Extended laying time.
-
High vapor permeability.
-
No shrinkage, high crack resistance.
-
Resistant to freeze-thaw cycles.
-
Can be used in contact with drinking water.
- It is an ideal durable and elastic base for laying ceramic tiles on it without additional processing and intermediate layers.
Application area
-
Foundation waterproofing.
-
Floor waterproofing in a private house.
-
Floor waterproofing in the apartment.
-
Waterproofing the floor in the bathroom under the tiles.
-
Floor waterproofing before screed.
-
Waterproofing of basement walls (negative).
-
Waterproofing the floor in the garage.
- Floor waterproofing on an open balcony.
Specifications
|
Material MasterTile WP 665 |
Min. fillers, polymer-modified additives
|
|
Color |
Special
|
|
Adhesion strength |
≥1.0 N/mm2 (28d)
|
|
Resistant to positive water pressure |
0.5 bar positive
|
|
Application temperature |
+5°С…+25°С
|
|
Operating temperature |
-20°С…+80°С
|
|
Remix time |
3-5 minutes
|
|
Term of use |
2 hours
|
|
Period before operation |
2 days
|
|
Period before topcoating (tiles, plaster) |
3 days |
Surface preparation
-
The substrate must be free of defects, predominantly even, clean and finely porous, free of pits, voids, cracks, dust, tar, bitumen, old paint and other factors that impair adhesion.
-
Wood and metal inclusions should be removed and active leaks should be repaired with MasterSeal 591 or other methods.
-
Cavities and sinks must be filled with mixtures from the MasterEmaco series.
-
At vertical and horizontal corners, a rounding with a radius of at least 4 cm should be used.
-
The substrate must be thoroughly moistened before coating.
-
If the material, after being applied to the surface, begins to quickly lose water.
-
This means that the surface is not sufficiently moistened.
-
For application in conditions of high temperature or in windy weather, it is possible to increase the dosage of water by 10%.
Mixing
-
Pour in water and slowly add MasterTile WP 665 to a clean mixing container and mix at low speed 400-600 rpm for 3-5 minutes until a homogeneous mixture is obtained.
-
Leave the mixture for 3-5 minutes to ripen, then stir again for 30 seconds.
-
After that, the mixture is ready for use.
-
Ratio: 20 kg / 4.6 liters of water.
Application of MasterTile WP 665
-
The prepared mortar is applied by Thoro Brush with a brush or spatula in 2 or 3 layers in perpendicular fusing one to the other.
-
The time interval between layers depends on the application conditions.
-
Consumption (powder).
-
1st layer - 1.5 kg / m2.
-
2nd layer - 1.3 kg / m2.
- 3rd layer - 1.2 kg / m2.
Important aspects when applying
-
The film thickness of each coating layer should not exceed 2mm.
-
The air temperature and the substrate temperature must be at least 5º C or not more than 25º C.
-
Do not use MasterTile WP 665 in the rain or if there is a chance of rain.
-
MasterTile WP 665 applied at +23°C gains mechanical strength after 2 days, becomes waterproof after 7 days and gains final strength after 14 days.
-
The coating must be protected from direct sunlight, wind, frost or rain for 24 hours.
-
The application time of systems based on cement and acrylic emulsions depends on the temperature and relative humidity of the air.
-
At low temperatures, the reaction slows down, which increases the working time and setting time.
-
High temperature speeds up the reaction and the times mentioned above are reduced.
-
In order for the material to harden, the temperatures of the material, substrate and air cannot be less than the minimum permitted temperatures.
-
Areas that are not yet fully cured should not come into contact with water.
-
Do not use MasterTile WP 665 as a pavement in pedestrian areas, additional surface protection is required.
-
The coating must be protected with a screed (based on the modifying additive MasterCast 125 ) or ceramic tiles.
- Apply, for laying tiles, materials from the MasterTile series.
Cleaning tools
-
Clean tools and equipment with warm soapy water after use.
- Once MasterTile WP 665 has hardened, it can be mechanically removed from the surface.
Package
Bag 20kg.
Storage
-
Store in original, unopened packaging in cool, dry conditions, protected from frost.
-
For short-term storage, a maximum of 3 pallets can be stacked one on top of the other.
-
For long-term storage, pallets cannot be stacked one on top of the other.
Best before date
-
MasterTile WP 665 has a 12 month warranty in unopened, undamaged packaging.
-
Store bags only on pallets covered with stretch film in a dry place.
-
Protect from direct sunlight and rain.
-
Failure to comply with the recommended storage conditions may result in damage to the material or packaging.
- Opened packages must be tightly closed immediately and used within one week after opening.
Security measures
-
Do not approach storage facilities during a fire;
-
Store products in well-ventilated areas;
-
During work, work clothes, protective gloves, goggles and a mask should be used in accordance with health and safety regulations;
-
Since uncured materials have an irritating effect, contact of the components with the skin and eyes should not be allowed, and in case of contact, rinse with plenty of water;
-
If swallowed, seek medical attention immediately;
-
It is forbidden to bring food and drink to the construction site where the product is used;
-
The product must be kept out of the reach of children.
