VIVALTOP CURE | Varnish for the floor

Acrylic varnish, membrane forming agent for concrete and topping floors

Description

Characteristics

Application

VIVALTOP CURE | This is a colorless solution, a special soluble acrylic resin.

VIVALTOP CURE is a drug that protects the surfaces of new and old concrete coatings.
VIVALTOP CURE - applied to a freshly rubbed, finished surface, forms a thin dense shell and penetrates the top layer of concrete or VIVALTOP topping.

The pores on the surface of the concrete are closed, and the release of water from the concrete is reduced, which as a result protects and protects the coating from the rapid loss of moisture and the reduction of cracking;
It is not subject to aging, binds to the structure of the concrete coating, which strengthens and protects.
As a means, protective and primer varnish, for new, old concrete industrial floors;

Composition	Acrylic resin, solvents, modifying agents
Consumption	100-200 ml / m2, (5-10 m2 / l) with a single application
Application temperature	Min. 5oC
Drying time at temp. 20oC, to the touch	- 2-4 hours Full - in 24 hours
The effectiveness of braking, the process of evaporation of water	At least 75%
Density	0.90-0.95 g / cm3

Before applying VIVALTOP CURE, the surface of the base must be clean and free of stagnant water;
The product is intended for use immediately after the final grouting of the concrete surface;
In order to control the flow of material, the floor surface should be divided into areas suitable for application.

The best temperature for application is between 10 ° C and 25 ° C;
At a temperature below 10 ° C, the evaporation process and the creation of the active substance may occur with a delay, which leads to the production of a coating with worse parameters.

Strong wind and strong rays of the sun can accelerate the process of evaporation of the substance, adversely affecting the depth of penetration;

VIVALTOP CURE must be sprayed on the newly laid concrete floor immediately after the last mechanical grouting;
With very low air humidity, strong sun or strong drafts, it is necessary to protect the floor from too rapid evaporation of water;

The drug is applied only once, in a thin layer, avoiding the formation of puddles;

An excess of VIVALTOP CURE, which has not penetrated deep into the floor, creates a thin film that will eventually wear off during operation;
This has no negative consequences for the mechanical properties of the floor;
Cutting deformation seams, as well as the effect of water or oil on a wet and not dried surface, can cause local color changes;

A very thick layer of VIVALTOP CURE will cause a dark color on the surface of the floor, since the floor will release moisture more slowly in these places.

Stores up to 12 months, in a ventilated dry, cold room, at a temperature > 0oC, in the original closed packaging;
Apply in a well-ventilated room away from fire;
Avoid inhalation of vapors and contact with skin and eyes;
To wash tools, use acetone or xylene.

The given technical characteristics are based on laboratory tests;
The practical results of the measurements may differ from those given, due to circumstances beyond the manufacturer's control;
All the specified information is reliable and takes into account the current state of affairs, as well as the existing experience;
Before using the product on a large scale, it is recommended that the buyer conduct a test of application in specific natural conditions of construction;
The supplier does not influence the methods of application, methods of application and conditions of implementation that arise on the construction site, therefore, his responsibility for the final result of application cannot arise from this instruction.